Omega Engineering OMB-CHARTSCAN 1400 User Manual page 93

The mode is selected from the lower left-hand portion of the dialog box. The following figure
represents a screen capture with normal mode selected.
The following figure depicts components of an acquisition. The Trigger and Stop Points represent the
entries described under the Event Configuration selection in the table on the following page.
In the "High-speed, single-channel" mode the Scan Intervals parameters section is replaced with a
High-Speed Setup parameters section with boxes for selection of Channel and Scan Rate, as indicated
in the following figure.
ChartScan User's Manual
Acquisition Setup Dialog Box, Normal Mode
In the High-speed, single-channel (burst mode), all ChartView display functions are
intentionally disabled. Data acquisition and storage to disk are the only services that
remain functional. When you select the High-speed, single channel mode, a Warning
dialog box appears with this information, providing you with the opportunity to cancel if
desired.
Reference Note: Burst mode operational constraints are discussed in greater detail on
page 4-39.
ChartView Software Reference 4-37