Scancal Software Application; Scancal's Main Window; Using Scancal - Omega Engineering OMB-CHARTSCAN 1400 User Manual

ScanCal Software Application

ScanCal's Main Window

Select the ScanCal option from the ChartView Program Group. ScanCal's Main Window will appear. The
window contains pull-down menus, a toolbar, and calibration instructions.
The options available from the pull-down menus (
offered by the toolbar, with one exception: the
Upload Cal Constants

Using ScanCal

To use ScanCal, simply follow the four steps listed under the word Instructions in ScanCal's Main Window.
The steps are repeated below, along with the proper tool icon and equivalent pull-down menu option.
Instructions for setting up calibration equipment are contained in specific sections of this chapter, for
example, the section Offset Calibration of Main Unit details how to use a calibration card and either of two
shorting methods.
Step
1
2
3
4
Note: The following text discusses the use of the tool icons. However, if desired, the pull-down menus
can be used instead.
ChartScan User's Manual
Unless you are setting main unit calibration constants or changing the password,
the calibration mode should be disabled.
The calibration mode applies to main unit calibration, and not to the calibration of
signal conditioning cards.
.
ScanCal Main Window and Icon Legend
ScanCal Main Window Pull-Down Menus
Instruction
Verify the interface parameters
Click the inventory tool to perform a system inventory.
Select the desired devices from the inventory list.
Click the calibrate tool.
CAUTION CAUTION
CAUTION CAUTION
, and
File, Instrument
pull-down menu contains a selection to
Calibrate
Icon Legend
Open Interface Parameters
Save Interface Parameters
Setup Interface Parameters
Inventory Instrument System
Calibrate Selected Devices
Tool Icon
) are the same as those
Calibrate
Pull-down Menu
Dip Switch File menu
Icon
Inventory Instrument menu
Icon
Inventory Instrument menu
Icon
Calibrate Calibrate menu
Icon
Calibration 6-3