Omega Engineering OMB-CHARTSCAN 1400 User Manual page 152

API Commands
TYPE
EXECUTION
SYNTAX
DESCRIPTION
Using the Select Card (
cause subsequent
calibration factors of the cards as part of the system, select a number from the range
EXAMPLE
PRINT#1, "OUTPUT07;C#0X"
PRINT#1, "OUTPUT07;QC?X"
PRINT#1, "ENTER07"
INPUT #2, A$
PRINT#1, "OUTPUT07;C#5X"
PRINT#1, "OUTPUT07;U12X"
PRINT#1, "ENTER07"
INPUT #2, A$
PRINT#1, "OUTPUT07;C#105X"
PRINT#1, "OUTPUT07;QC?X"
PRINT#1, "ENTER07"
INPUT #2, A$
Note: In the above example an expansion chassis is being used, thereby allowing an additional 4 card slots.
Note: Card #5 will typically be located in slot #5; however, if the optional relay card is used, card #5 will be located
in slot #6 and signal conditioning card use is limited to 7 cards (instead of 8).
A-26
- Select Card
C#
Calibration
Immediate
Select the card from which subsequent
C#card
retrieve information.
Without optional Relay Card
Valid options for
card in corresponding slot of the main unit (with 1 being the bottom slot);
and 5, 6, 7, or 8 - Selects the corresponding slot on the expansion chassis
(with slot 5 being the bottom slot of the expansion chassis.
With optional Relay Card Installed (installs in slot 1)
Valid options for
2 selects card in slot 3; and so on, with 7 selecting the card in slot 8; and
no card 8 available.
) command, selecting a number from the range
C#
commands to return the calibration factors of the cards by themselves. To return the
QC?
QC?
are: - Selects the chassis; 1, 2, 3, or 4 - Selects the
card 0
are: - Selects the chassis; 1 selects card in slot 2,
card 0
1-8
' Select chassis
' Read chassis calibration factors
' Select the card #5
' Read back the time/date that card #5 was last calibrated
' Select the card #5 in order to read back the calibration factors
as part of the system
' Read back the system calibration factors of card #5
Appendix A
and interrogation will
U12
for the parameter will
card
.
101-108
ChartScan User's Manual