Table of Contents
Advertisement
4.2 INSTALLING THE PRINTER ON THE STAND
Install the stand to the main unit according to the following procedure:
Step 1 :
Position the stand correctly (with the PCB box screw holes to the right).
Step 2 :
Insert the lifting tubes in the brackets and tighten them with each two wing screws.
Step 3 :
Lift the body with at least 4 people (refer to local regulations) and put it on the stand.
Step 4 :
Remove the lifting tube brackets. Use a 5 mm hexagon key (inside accessory kit).
CS9200 Low Solvent series printers
26
AP-40301 – Rev. 2.0 – 02/05/2008
Advertisement
Table of Contents
