Table of Contents
Advertisement
d. Repeat this for all eight cassettes.
e. When finished, remove all cleaning cassettes.
Step 16 : Please wait while printer is sucking air
Step 17 : Insert 8 NEW cassettes with Low Solvent Ink in the correct order when following message is
displayed.
Step 18 : The printer will automatically start pumping ink when all cassettes are inserted.
Step 19 : Empty the waste bottle when asked and confirm later on with ENTER.
Step 20 : Perform a NozzleCheck and some cleanings if necessary.
Step 21 : If all nozzles are present, the first ink load procedure has been finished successfully.
Notes
When you have used a syringe to complete the first ink load procedure, it doesn't mean necessarily that
there is something wrong with the printer.
During an ink load, air columns will be created to ease the switch between two liquids. When these air
columns are too big, it might be possible that the pump experiences difficulties and that you have to
intervene manually.
+
When you perform a NozzleCheck and all nozzles are present, no problems will occur during normal
printing activities.
-
When you perform a NozzleCheck and still a lot of nozzles are missing, you will have to search for the
reason, may be a pump is broken or the tube cycle is not complete air tight.
CS9200 Low Solvent series printers
45
AP-40301 – Rev. 2.0 – 02/05/2008
Advertisement
Table of Contents
