Table of Contents
Advertisement
Step 5 :
The first printed blocks are the reference and the blocks printed secondly should be aligned with
the reference blocks. Refer to the image below to know in which direction.
Second blocks are printed too much
to the right side (too late)
► decrease (-) the bi-dir value as
described in the next step
Step 6 :
Increase or decrease all necessary bi-dir values as follows:
a. Select the head height in which you want to adjust the bi-dir values.
b. All nozzle rows (1A, 1B, 2A, 2B ...) will pass in order on the display. If you do not want to
change the value, press the ENTER key. The setting will be kept unchanged.
Change the value with the [F2] or [F4] key and confirm with the ENTER key.
c. After setting all values (8B as last one), the adjustment pattern for the particular head height
will be printed once again.
Step 7 :
Perform this procedure for all head heights and for all carriage speeds; which means
Bi-D
Bi-D400
Bi-D480
►
Adjustment [F2]
►
Adjustment [F2]
►
Adjustment [F2]
CS9200 Low Solvent series printers
Second blocks are printed too much
to the left side (too soon)
► increase (+) the bi-dir value as
described in the next step
►
Menu 2/4
►
Bi-D [F1]
►
Menu 4/4
►
Bi-D400 [F3]
►
Menu 4/4
►
Bi-D480 [F4]
54
AP-40301 – Rev. 2.0 – 02/05/2008
Advertisement
Table of Contents
