Lighting For The First Time - Piazzetta P963 Instructions For Installation, Use And Maintenance Manual

NUMBER KEY / DISPLAY
1 Key ON/OFF
2 Key STAND-BY
3 Key POWER
4 Key FAN SPEED
5 Key SELECT
6 Key TEMPERATURE
7 Key TIMER
8 Key MENU
9 Key SET
10 Key MENU SELECTION
11 Key ESC
12 Key OPT
13 Display
14 Display POWER
15 Display MULTIFUOCO
16 Display DAYS OF THE WEEK
17 Display RADIO SIGNAL EMISSION
18 Display TIMER
19 Display SAFETY
20 Display FLAT BATTERY

6.3 LIGHTING FOR THE FIRST TIME

• Before lighting the stove for the fi rst time, check that the grate is properly placed and pushed back towards the baffl e plate.
• There will be odours when lighting the fi rst few times due to the evaporation of paints and oils used during the manufacturing process.
During this stage, air the room well where the stove is installed and avoid staying there any length of time since the fumes being given off could be
harmful to persons or pets.
The stove body should have settled down and the paints fully evaporated after having lit the stove a few times.
To this end, follow the instructions given below when using the stove:
- operate at medium power for the fi rst 5-6 hours after igniting the fuel (the expansion caused by the heat during this stage will allow the stove
body to settle);
- after the settling-down stage the stove must be set to operate at maximum power for a period between 6 and 10 hours, depending on the amount
of paint on the stove body that must be evaporated off.
The time indicated for operation at maximum power does not necessarily have to be continuous, but may be divided up into two periods separated
by an interval of at least 3-4 hours with the stove shut down.
At the end of the recommended period the paint will have evaporated and the stove should be used at the suitable power for normal use.
If necessary the stove may be used for a further period at maximum power to ensure complete and fi nal disappearance of all paint residue.
When the hopper is being loaded for the fi rst time the loading auger needs time to fi ll up; during this stage the pellets are not distributed inside the
fi rebox and it is highly probable that the fi rst attempt at ignition fails. If the alarm is activated, shut down the stove by pressing the ON/OFF key for a
few moments, remove the fuel in the grate and then set the stove for a new ignition process.
Dispose the not burned pellets contained in the brazier.
24
Allows you to start up or shut down the stove.
Pressing the stand-by key and holding it down (for around 5 seconds) until KEYPAD BLOCKED
appears on the display will disable the keypad. To re-enable the keypad press the stand-by key
and hold it down (for around 8 seconds) until KEYPAD UNBLOCKED appears on the display.
Allows you to select the power setting. With the SELECT key you can choose between the fi ve
available settings, P1-P2-P3-P4-P5.
Allows you to choose the speed setting on the Multifuoco fan. With the SELECT key you can
choose between the four available settings, 01-02-03-04.
Allows you to choose: • power level - having previously pressed the POWER key
• fan speed - having previously pressed the FAN SPEED key
• temperature - having previously selected the TEMPERATURE key
Allows you to set the room temperature. The SELECT key will allow to choose the desired
temperature between 7°C and 30°C.
Displays the current date and time.
Allows: • access to the programming menu
• return to the initial display
Confi rm MENU selected
Scrolls through the programming MENU
Returns to previous menu
Displays the MULTICOMFORT temperatures. The dash before the temperature shows which
sensor is giving the temperature reading.
Shows on three lines the function settings, the current time and the temperature.
Shows the power setting selected, P1-P2-P3-P4-P5.
Shows the Multifuoco setting selected, 01-02-03-04. The two lines of squares to the left and to
the right show respectively the left or right fan.
Shows the day of the week, 1 Monday, 2 Tuesday, 3 Wednesday, 4 Thursday, 5 Friday, 6 Saturday,
7 Sunday.
Active if the remote is receiving data from the stove
Shows that the timer is engaged
Symbol appears when the safety system is activated
Shows that the battery is fl at or running down
H07025410 / DT2000678 – 00
DESCRIPTION
DT2010082-06