Section Ii - Getting Ready To Sew; Connecting The Machine To Power Supply And Foot Control - ELNA 3210 Instruction Manual

3230
1
3210
1
5
2
4
3
5
4
2 3
SECTION II
Getting Ready to Sew
Connecting the Machine to Power Supply
and Foot Control
Your machine is equipped with a detachable power cord.
Before connecting the power cord, make sure the voltage
and frequency shown on the machine are identical to
your electrical power.
Check that the power/light switch
Insert the machine plug
the machine and the power supply plug
socket.
Your machine may come equipped with a polarized plug
(one prong wider than the other). A polarized plug
reduces the risk of electrical shock. This plug is intended
to fit into a polarized outlet. If the plug does not fit fully
into the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Switch ON the machine
IMPORTANT: Before using your sewing machine the first
time, place waste fabric under the presser foot and run
the machine without thread for a few minutes. Wipe away
any excess oil.
For Your Safety
1. Always turn off the power/light switch first and then
unplug from the electrical outlet. Examples:
• when leaving the machine unattended
• when cleaning the machine
2. Always turn off the power/light switch:
• when attaching or removing parts such as needle,
presser foot, needle plate
• when threading needle or bobbin
3. Do not use extension cords or plug adapters.
4. Do not touch plug with wet hands.
5. Do not place anything on the foot control.
6. Do not place heavy items on cords. Do not subject
cords to heat. Do not use damaged cords. Have the
cord repaired immediately.
7. While the machine is in operation, always keep your
eye on the sewing area and do not touch any moving
parts such as the thread take-up lever, flywheel or
needle.
22
1
is in the off position.
2
and foot control plug
4
into the wall
5
.
3
into