Getting Ready To Sew Connecting The Power Supply; Using Start/Stop Button - ELNA eXcellence 782 Instruction Book

(1)
2.
(3)
(2)
GETTING READY TO SEW
Connecting the Power Supply

Using Start/Stop Button

1.
1. First make sure the power switch is off.
2. Insert the machine plug of the power supply cable
3.
3. Insert the power supply plug into the wall outlet, and
NOTE:
(5)
3.
• Make sure to use the power supply cable that came
with the machine.
(4)
• If you turn off the power switch, wait for 5 seconds
before turning it on again.
• While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts
such as the thread take-up lever, handwheel or
needle.
• Always turn off the power switch and unplug the
machine from the power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
• Do not place anything on the foot control.
Before Using Your Sewing Machine
Before using your sewing machine for the first time,
place a scrap of fabric under the presser foot and run the
machine for a few minutes.
Wipe away any oil which may appear.
Operating Instructions:
The symbol "O" on the switch indicates the "off" position
of the switch.
For the U.S.A. and Canada only
Polarized plug (one blade wider than the other):
To reduce the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If it does not fit
fully in the outlet, reverse the plug. If it still does not fit,
contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
12
into the machine socket.
turn the power switch on.
(1) Power switch
(2) Machine plug
(3) Machine socket
(4) Power supply plug
(5) Wall outlet
WARNING: