Stitch Selection Knob; Stitch Width/Needle Position Dial - ELNA 3210 Instruction Manual

Stitch Selection Knob

The needle must be at a high position before selecting a
stitch. Hand turn the flywheel toward you to raise the
needle. OR Press the Up/Down Needle key until the
needle is in an up position (Model 3230 only).
Turn the stitch selection knob 1 until the desired stitch is
2
shown in LCD Screen 2 (Model 3230 only) or Stitch
Selection Display 3 (Model 3210 only).
1
3
1
Model 3230 Only
If the LCD Screen only shows arrows and no stitch
information, the stitch selection knob is not positioned
correctly. Move the stitch selection knob until a stitch is
displayed.

Stitch Width/Needle Position Dial

1
The needle must be at a high position before changing
stitch width or needle position. Hand turn the flywheel
toward you to raise the needle. OR Press the Up/Down
Needle key until the needle is in an up position (Model
3230 only).
Turn the stitch width/needle position dial to align the
1
desired stitch width with the setting mark The lower the
number, the narrower the stitch. The higher the number,
the wider the stitch. The widest width this machine can
sew is 6.5 mm.
NOTE: If the setting is "0" the machine will sew a straight
stitch (or triple seam) in center needle position.
46