Ii Getting Ready To Sew; Connecting The Machine To The Power Supply; Needle Up/Down (Model 3007; Foot Control - ELNA 3003 Instruction Manual

II GETTING READY TO SEW NEEDLE UP/DOWN FOOT CONTROL
(MODEL 3007)
CONNECTING THE MACHINE
TO THE POWER SUPPLY
for high speed, set the switch at 'HIGH"
-
.
(230V) or ""
(120V),
For low speed, set the switch at "LOW"
I~\(230
VI of 'Cp 10V
*
Do not move the switch when the machine
..- "'s
running.
41J
.SEWING
LIGHT
• -A
pressure on this key, when the machine is Sewing speed can be varied by the foot
not running, makes the needle rise or come
control.
down The harde you press on the control, the faster
-
If ;he needle is in the upper position, it will the machine runs
come
down into
the
fabric and vice versa
CAUTION: Don't press the foot control whilst
(B)
the needle up/down key is depressed.
40
This key is used for,
l-'•lJ• • •Making the bobbin thread come up
Maki•on/upg hod
d
the bobbin••
tThe
sewing lght is located behind the face
(down/up), hold the end of thCobbi
thread.
plate.
-Sewing an angle (make the needle go
down before turning the fabric).
SPEED REDUCER
)A)To remove
Pull out
MODEL 3007
To replace
Push
in while the pins are
MODEL 3007in
line with the holes of light
Thus it is no longer necessary to turn the
The sewing speed range can be varied by
inliet
balance wheel by hand to raise and lower
the speed reducer
Bef~or connecting, make sure tha I the voltage the needle. tesedrdcr
of the power supply is identical to that of the
For a higher speed, slide it to the right, for
0
FB) To remove Push and turn to the left.
machine With the switch on "OFF", fit the non
lower speed slide it to the left. To replace
Push and turn to the right.
reversible plug into the machine socket and plug
the machine into the wail socket Switch it on
MODELS
3003
+
3005
N.B. When replacing the bulb, unplug the
The sewing speed range can be varied by
machine Use a bulb of:
NB. Make ita habit to switch off the machine
the switch situated on the front of the foot [A)Halogen lamp 123V/3W
when you are not using it
control. (B}Tungsten lamp: 15 W max,