Enerzone Euromax EP00070 Installation And Operation Manual page 91

Before installing the thermostat, unplug the power cord from the power outlet.
First, connect the two thermostat wires to the terminal block located at the rear on the right
hand side of the stove when facing it. Loosen the two middle screws and insert the wires in
the terminals. Tighten the two screws. Open the thermostat and connect the wires as per the
manufacturer's instructions.
Here is an example of what your thermostat could look like:
Connect one wire on "RH" and the other wire on "W". Red wire jumper can remain installed.
For further information refer to the manufacturer's instructions.
91
Euromax Pellet Stove Installation and Operation Manual