Selecting The Pilot Cycle - Enerzone Euromax EP00070 Installation And Operation Manual

6.1.9 Selecting the Pilot Cycle

To change the pilot cycle press the word "AUTO" from the Main Status Page. You can choose
from one of the four different pilot cycles: "ALWAYS ON", "30 MINUTES", "60 MINUTES", or
"ALWAYS OFF". The selected cycle will be displayed under the word "AUTO" on the main
status page. Default setting is "ALWAYS OFF" since this is the most fuel efficient
configuration.
Press on AUTO
button to set
pilot time settings
Note: Pilot feed rate is lower than the minimum combustion level feed rate.
6.1.9.1 Always OFF
When the "ALWAYS OFF" pilot cycle is selected, the stove will shut down when the
temperature set on the thermostat is reached. Every time the thermostat will call for heat, the
stove will go through the complete ignition cycle.
6.1.9.2 30 Minutes or 60 Minutes
The pilot cycle begins when temperature set on the thermostat is reached. It will last 30 or 60
minutes depending of the selected pilot cycle. If the thermostat does not call for heat before
the end of the selected pilot cycle delay, the stove will shut down and will need to go through
the complete ignition cycle when the thermostat calls for heat again.
6.1.9.3 Always ON
The pilot cycle begins when temperature set on the thermostat is reached. When the
"ALWAYS ON" pilot cycle is selected, the stove will remain on pilot mode until the thermostat
calls for heat.
Euromax Pellet Stove Installation and Operation Manual
35