Configuration Commands; Module Commands - Nortel Passport 8672ATME Using Manual

76 Chapter 5 Managing the Passport 8672ATME Module with the CLI

Configuration commands

This section describes the CLI configuration commands available with the
Passport 8672ATME Module. There are three types of configuration commands:
• "Module
• "1483 ELAN statistics" on page 77
• "Port commands" on page 79

Module commands

The module commands allow you to:
• Reset the module
• View ELAN statistics
• Display the image filename for the Passport 8672ATME Module.
The syntax is:
config atmcard
The required variable
the Passport 8600 chassis.
config atmcard command.
209195-B
commands," next
Note: If you replace one card with another type of card, Nortel
Networks recommends that you go to the root level of the CLI directory
before using any CLI commands.
< atmslot number >
< atmslot number >
Table 15
is the slot number of the module in
describes the parameters and variables for the