Config Atm Pvc Command; Table 18 Config Atm Pvc Command Parameters And Variables - Nortel Passport 8672ATME Using Manual

Table 17 config atm command parameters and variables (continued)
Parameters and variables
state <enable | disable>
info

config atm pvc command

Table 18
command.

Table 18 config atm pvc command parameters and variables

Parameters and variables
create < vpi.vci> [name <value>]
[enc <value>] [serv <value>] [pcr
<value>] [scr <value>] [mbs
<value>]
Chapter 5 Managing the Passport 8672ATME Module with the CLI
Description
Sets the state of the port to enabled or disabled.
Shows the last saved port settings and the next-level CLI commands.
Note that this does not show the current settings, but the last saved
settings.
describes the parameters and variables for the config atm pvc
Description
Creates a PVC. The required parameters are:
• vpi is the circuit VPI. Enter a numeric value, within the range.
• vci is the circuit VCI. Enter a numeric value, within the range.
For OC-3c, 11 bits split between Vpi and Vci. Vpi bits cannot
exceed 6 bits for OC-3c.
For OC-12c, 13 bits split between Vpi (default is 4) and Vci (default
is 9). Vpi bits cannot exceed 8 bits for OC-12c.
Note: For <vpi.vci>, 0.0 is not supported.
The optional parameters are:
• name is the display string. Enter up to 256 alphanumeric characters
to name PVC.
• enc is the 1483 encapsulation method, either null or llc-snap.
• serv is the bit rate, either ubr or vbr.
• pcr, with VBR only, is the peak cell rate. The valid ranges are:
OC-3—86..182783
OC-12—86..733490
• scr, with VBR only, is the sustained cell rate. The valid ranges are:
OC-3—86..182783
OC-12—86..733490
• mbs, with VBR only, is the maximum burst size. Enter an integer
from 2 to 255.
Note that no VLANs or ELANs are bound to this PVC until you add
VLAN membership using the config atm <ports> pvc 1483 commands.
Using the Passport 8672ATME Module
81