Config Atm Info Command; Figure 29 Sample Output For The Config Atm Info Command; Table 21 Config Atm Pvc 1483 Ipx Command Parameters And Variables - Nortel Passport 8672ATME Using Manual

84 Chapter 5 Managing the Passport 8672ATME Module with the CLI

Table 21 config atm pvc 1483 ipx command parameters and variables

Parameters and variables
create <vid> <vpi.vci> <ipx>
delete <vid>
info

config atm info command

Figure 29
info

Figure 29 Sample output for the config atm info command

number-vpi-bits : 4
209195-B
Description
Creates a routed 1483 IPX circuit on the specified VLAN to the
specified remote router interface. The optional parameters are:
• vid means VLAN ID number.
• vpi.vci means circuit VPI number and the circuit VCI numbers,
respectively; they are separated by a period.
• ipx is the IPX Network number of the remote router interface. If this
number is not given, the first IPX Network number configured for
the specified VLAN is used.
Note that the VLAN ID must be previously configured for IPX on this
port.
No ARP functionality is available on this IPX segment.
Deletes the routed 1483 IPX circuit on the specified VLAN.
Displays information on routed 1483 IPX circuits.
shows a sample of the output resulting from executing the
command.
framing-mode : SONET
clock-source : Free Running
loop-back-mode : off
scrambling : Enable
state : up
config atm