Nortel Passport 8672ATME Using Manual page 67

Chapter 4 Managing the Passport 8672ATME Module with Device Manager
5
In the VlanId field, type the VLAN ID.
6
In the PvcIds field, type the PVC ID.
Note: For <vpi.vci>, 0.0 is not supported.
7 In the ConnectType field, select the type of routing protocol: bridged, ip, or
ipx.
8
If bridged is selected in the ConnectType field, click Insert.
9
If Ip is selected in the ConnectType field, complete the following fields:
a
In the LocalIpAddress field, type the IP address of the device.
b In the RemoteIpAddress field, type the IP address of the device that you
are connecting to in the 1483 ELAN.
c
Select the InArpSendEnable option to enable Arp packets.
d In the InArpSendInterval field, type the time interval between 0 and 60
seconds.
e
Click Insert.
Figure 22 shows the relevant fields for IP routing.
Using the Passport 8672ATME Module
67