Table 20 Config Atm Pvc 1483 Ip Command Parameters And Variables - Nortel Passport 8672ATME Using Manual

Table 19 config atm pvc 1483 bridged command parameters and variables (continued)
remove <vid> <vpi.vci>
[,<vpi.vci>]...
info
Table 20
1483 ip command.

Table 20 config atm pvc 1483 ip command parameters and variables

Parameters and variables
create <vid> <vpi.vci> <remoteip> Creates a routed 1483 IP circuit on the specified VLAN to the
delete <vid>
info
Table 21
1483 ipx command.
Chapter 5 Managing the Passport 8672ATME Module with the CLI
Removes a number of PVCs from the specified 1483 ELAN. The
required parameters are:
• vid means VLAN ID number.
• vpi.vci means circuit VPI number and the circuit VCI numbers,
respectively; they are separated by a period.
Note that this command fails if the PVCs are not present.
Displays information on 1483 ELANs.
describes the parameters and variables for the config atm pvc
Description
specified remote router interface. The optional parameters are:
• vid means VLAN ID number.
• vpi.vci means circuit VPI number and the circuit VCI numbers,
respectively; they are separated by a period.
• remoteip is the IP address of the remote router interface.
Note that the VLAN ID can exist only on this port.
Deletes the routed 1483 IP circuit on the specified VLAN.
Displays information on routed 1483 IP circuits.
describes the parameters and variables for the config atm pvc
Using the Passport 8672ATME Module
83