Changing The Clock Setting Using Device Manager - Nortel Passport 8672ATME Using Manual

118 Chapter 6 Configuring the Passport 8672ATME Module
Before you can pass traffic using the Passport 8672ATME Module with its
installed MDA, you must change the clock setting. You can do this in one of two
ways:
• "Changing the clock setting using Device
• "Changing the clock setting using the CLI" on page 119

Changing the clock setting using Device Manager

This section provides instructions on changing the clock setting.
To change the clock setting using Device Manager:
1 Highlight the port.
2 Choose Edit > Port.
The Port dialog box opens with the Interface tab displayed
page
3
Click the ATM tab.
The ATM tab opens.
209195-B
Note: The Passport 8672ATME Module supports only Ethernet ELANs.
Note: If you are connecting one Passport 8672ATME Module directly
to another Passport 8672ATME Module without going through the
SONET cloud, the clock mode at both ends of the circuit may be
free-running, but only one end of this circuit may be configured as
loop-timed.
52).
(Figure
Manager," next
49).
(Figure 12 on