Config Atm Pvc 1483 Command; Table 19 Config Atm Pvc 1483 Bridged Command Parameters And Variables - Nortel Passport 8672ATME Using Manual

82 Chapter 5 Managing the Passport 8672ATME Module with the CLI
Table 18 config atm pvc command parameters and variables (continued)
delete <vpi.vci>
info [<ports>]

config atm pvc 1483 command

Use the config atm pvc 1483 commands to configure 1483 parameters on
the Passport 8672ATME Module. The syntax is:
•
config atm <ports> pvc 1483 bridged
• config atm <ports> pvc 1483 ip
• config atm <ports> pvc 1483 ipx
Table 19
pvc 1483 command.

Table 19 config atm pvc 1483 bridged command parameters and variables

Parameters and variables
add <vid> <vpi.vci> [,<vpi.vci>]...
create <vid> <vpi.vci>
[,<vpi.vci>]...
delete <vid>
209195-B
Deletes the specified PVC. Note that this command will fail if the PVC is
still being used by RFC 1483 traffic.
Displays PVC information.
describes the parameters and variables for the config atm < ports >
Description
Adds a number of PVCs to the specified 1483 ELAN. The required
parameters are:
• vid means VLAN ID number.
• vpi.vci means circuit VPI number and the circuit VCI numbers,
respectively; they are separated by a period.
Note: This command fails if the specified VIDs or VPI/VCI pairs belong
to another ELAN or already exist on this ELAN.
Creates a 1483 ELAN consisting of the specified PVCs. The required
parameters are:
• vid means VLAN ID number.
• vpi.vci means circuit VPI number and the circuit VCI numbers,
respectively; they are separated by a period.
Note: This command fails if the specified VIDs or VPI/VCI pairs belong
to another ELAN or already exist on this ELAN.
Deletes the specified ELAN.