Configuring A Null-Encapsulation Pvc; Associating The Pvc With The Vlan; Configuring An Ip Routing 1483 Pvc Using The Cli - Nortel Passport 8672ATME Using Manual

136 Chapter 6 Configuring the Passport 8672ATME Module
Table 48 OSPF tab fields (continued)
Field
AreaId
AdvertiseWhenDown
5
Click Enable.
6
Click Apply.
The OSPF tab closes, and the IP Address tab is redisplayed.
7
Click Close.

Configuring a null-encapsulation PVC

See "Configuring two ATM 1483 PVCs on the same ATM port" on page

Associating the PVC with the VLAN

See "Associating the PVC with the VLAN" on page
Follow the instructions there except, in the ConnectType field, select IP instead of
bridged.

Configuring an IP routing 1483 PVC using the CLI

To configure the Passport 8672ATME Module for an ATM 1483 IP routed PVC,
using the CLI:
1
To create two VLANs by port, enter:
config vlan 2 create byport 1
config vlan 3 create byport 1
209195-B
Description
A 32-bit integer uniquely identifying the area to which the
interface connects. Area ID 0.0.0.0 is used for the OSPF
backbone.
Value used indicates whether or not a VLAN state change
should be notified to layer 3, provided that the VLAN is
configured as a routable interface. Also used for single routable
ports. In that case, the criteria for state is PortOperStatus.
128.
126.