Bridging Point-To-Point Traffic Using An Atm 1483 Pvc Using The Cli; Bridging Point-To-Multipoint Traffic Using An Atm 1483 Pvc Using Device Manager - Nortel Passport 8672ATME Using Manual

5
Click Insert.
The Insert ATM 1483 ELAN dialog box closes, and the ATM 1483 ELAN tab
is redisplayed.
6 Click Close.
Bridging point-to-point traffic using an ATM 1483 PVC using
the CLI
To configure the Passport 8672ATME Module for ATM 1483 PVCs for VLANs
bridged across an ATM PVC network, using the CLI:
1
To create a VLAN by port, enter:
config vlan 2 create byport 1
2 To add an ATM port (in this example, 1/1) and several Ethernet ports (in this
example, 3/40 to 3/48) to the VLAN, enter:
config vlan 2 port add 1/1, 3/40-3/48
3
To configure an ATM 1483 PVC for null-encapsulation and ubr, enter:
config atm 1/1 pvc create 0.100 enc 1483-null serv
ubr
Alternatively, to configure an ATM 1483 PVC for null-encapsulation and vbr,
enter:
config atm 1/1 pvc create 0.100 enc 1483-null serv
vbr<PCR value>scr<SCR value> mbs<MBS value>
4
To associate the ATM 1483 bridged PVC with a VLAN, enter:
config atm 1/1 pvc 1483 bridged create 2 0.100,
0.101
Bridging point-to-multipoint traffic using an ATM 1483 PVC
using Device Manager
In the configuration shown in
configured as a bridging hub to spokes through the WAN. Bridging is not allowed
between PVCs in the same ELAN. For point-to-multipoint bridging, the end
stations connected by each PVC circuit cannot communicate with one another.
Chapter 6 Configuring the Passport 8672ATME Module
Figure 54, the Passport 8672ATME Module is
Using the Passport 8672ATME Module
127