Show Ports Info Atm Pvc [Slot/Port] - Nortel Passport 8672ATME Using Manual

Table 39 F5-OAM Loopback parameters (continued)
Configuration Default
down <value> 5 responses
trap <value> disabled
For example, to enable F5-OAM Loopback for VPI=0 & VCI=33 in port 6 of an
ATM card in slot 3, and configure it with trap enabled, a retry-frequency of 2
seconds and up-count of 5 times, you would enter the following command:
Passport-8610:5#
retry 2 up 5
To disable the F5-OAM Loopback for VPI=0 & VCI=33 in port 6 of an ATM card
in slot 3:
Passport-8610:5#

show ports info atm pvc [slot/port]

The
F5-OAM Loopback configuration among other PVC configurations.
Figure 47
[slot/port]
Chapter 5 Managing the Passport 8672ATME Module with the CLI
Values
1..255
Enable/Disable
config atm 3/6 pvc f5 0.33 enable trap enable
config atm 3/6 pvc f5 0.33 disable
show ports info atm pvc [slot/port]
displays sample output for the
command.
Description
Sets the number of consecutive F5-OAM Loopback
replies that must fail to change the Loopback State
to "down." This configuration is also referred as
"down-count".
Enables/disables the transmission of an SNMP Trap
when the F5-OAM Loopback changes from the
DOWN VERIFY to DOWN state or from the UP
VERIFY to UP state.
command displays the
show ports info atm pvc
Using the Passport 8672ATME Module
113