Network Setup Section - AMX NMX-ENC-N3121 Instruction Manual

Network Setup Section

The Network Setup section of the Settings page is shown in
Network Setup Section
FIG. 47
Settings Page: Network Setup Settings
TABLE 20
Option
IP Mode
IP address
Netmask
Gateway address
Trial Save
N3000 Series User Manual
Description
Configure the IP address mode. When set to AUTO IP,
an IP Address in the range of 169.254.xxx.xxx with
Netmask of 255.255.0.0 and Gateway address of
169.254.1.1 will be automatically assigned to the
N3000 Decoder by the control software. When set to
DHCP, an IP Address in the range of the DHCP server on
the network will be automatically assigned to the
N3000 Decoder. When set to STATIC, an IP address,
Netmask, and Gateway address must be manually
entered.
View the current IP address of the N3000 Decoder.
When in STATIC mode, you may enter a new IP address
into this field.
View the current Netmask of the N3000 Decoder. When
in STATIC mode, you may enter a new Netmask into
this field.
View the current Gateway address of the N3000
Decoder. When in STATIC mode, you may enter a new
Gateway address into this field.
Click to initially save IP address changes. Once you log
in to the unit using the new address, you will be able to
confirm and accept the changes permanently.
Figure 47. Options are described in
Notes
Using DHCP is generally not recommended. If the
device is set to DHCP and fails to receive an address
from the DHCP server in time, it will revert back to the
AUTO IP Address (169.254.xxx.xxx) until the unit is
rebooted.
Decoder Configuration Options
Table 20.
55