Network Setup Section - AMX NMX-ENC-N3121 Instruction Manual

Network Setup Section

The Network Setup section of the Settings page is shown in
Network Setup Section
FIG. 27
Settings Page: Network Setup Settings
TABLE 6
Option
IP Mode
IP address
Netmask
Gateway address
Manual DNS
DNS #1 and #2
Ping Test
Trial Save
N3000 Series User Manual
Description
Configure the IP address mode. When set to AUTO IP,
an IP Address in the range of 169.254.xxx.xxx with
Netmask of 255.255.0.0 and Gateway address of
169.254.1.1 will be automatically assigned to the
N3000 Encoder by the control software. When set to
DHCP, an IP Address in the range of the DHCP server on
the network will be automatically assigned to the
N3000 Encoder. When set to STATIC, an IP address,
Netmask, and Gateway address must be manually
entered.
View the current IP address of the N3000 Encoder.
When in STATIC mode, you may enter a new IP address
into this field.
View the current Netmask of the N3000 Encoder. When
in STATIC mode, you may enter a new Netmask into
this field.
View the current Gateway address of the N3000
Encoder. When in STATIC mode, you may enter a new
Gateway address into this field.
Enable to override the DNS selection.
Specifies the main servers for use for DNS.
Test connection by specifying an IP address or URL to
ping. Click the Ping link to initiate the test.
Click to initially save IP address changes. Once you log
in to the unit using the new address, you will be able to
confirm and accept the changes permanently.
Figure 27. Options are described in
Notes
Using DHCP is generally not recommended. If the
device is set to DHCP and fails to receive an address
from the DHCP server in time, it will revert back to the
AUTO IP Address (169.254.xxx.xxx) until the unit is
rebooted.
This is used for RTMP.
This is useful when in RTMP mode for verifying that
the unit can access the RTMP server.
Encoder Configuration Options
Table 6.
34