AMX NMX-ENC-N3121 Instruction Manual page 31

Settings Page: Advanced Settings (Cont.)
TABLE 4
Option
ARP Interval (secs)
Unsolicited Status
Send Status Address
Status Interval (secs)
Discovery Packet
Transmit
Discovery Interval
(secs)
TTL
DSCP #
IR Command Holdoff
IR Repeat Holdoff
Enable SNMP
N3000 Series User Manual
Description
Determine how often (in seconds) the unit transmits
gratuitous ARP packets.
Enable the Encoder to send a periodic status packet to
the Send Status Address described below.
When Unsolicited Status is enabled, the Encoder sends
a periodic status packet to the IP address specified
here.
Determine how often (in seconds) the unit transmits
status packets.
Enable the SVSI multicast discovery service (which is
used to identify units).
Determine how often (in seconds) the unit transmits
discovery packets.
Select the Time To Live (TTL) for the transmit audio and
video streams.
Select the Differentiated Services Code Point (DSCP) for
the transmit audio and video streams.
Set the delay between IR command portions. The
default setting is 25 ms.
Set the repeat delay between IR commands. The default
setting is 90 ms.
Enable to allow the device to handle Simple Network
Management Protocol (SNMP) queries.
Encoder Configuration Options
Notes
This is useful for larger network integrations when
broadcast packets will not cover the entire network.
Enabled by default.
Limits the lifespan of data on the transmit audio and
video streams (to improve performance).
IR commands are sent in two parts. This setting is the
time (in milliseconds) between transmission of part
one and part two. The second part of the command is
inverted for confirmation purposes.
This is the amount of time before a new command is
sent. For example, when pressing and holding the
volume button on a remote control, this is how long
until the command is repeated.
31