Status Section - AMX NMX-ENC-N3121 Instruction Manual

Status Section

The Status section of the Settings page is shown in
Status Section
FIG. 28
Settings Page: Status Section
TABLE 7
Option
DVI/HDMI Status
Input Resolution
DVI/HDMI Status Pass
Thru
Current Bandwidth
Port 50001 Source IP
Port 50002 Source IP
Serial Source IP
Flush buttons
N3000 Series User Manual
Figure
Description
Indicates if a video source is connected to the Encoder.
Indicates the video resolution of the currently
connected source.
Indicates if a display device is connected to the
Encoder.
This is a snapshot of the unit as properties were loaded
to the browser, not a live counter. Refresh the page to
get an updated bandwidth.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
Shows the IP address of the currently connected device
or displays Disconnected if no connection exists.
These buttons reset the ports.
28. Options are described in Table
Notes
Port 50001 can only accept a single external
connection at a time. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Port 50002 can only accept a single external
connection at a time. If a device is currently showing
the port occupied (by a control system or other
device), then other connections will be rejected.
However, connection attempts from the same IP will
override the current connection.
Only a single external connection can be accepted on
the port. If a device is currently showing the port
occupied (by a control system or other device), then
other connections will be rejected. However,
connection attempts from the same IP will override
the current connection.
Encoder Configuration Options
7.
35