AMX NMX-ENC-N3121 Instruction Manual page 53

Settings Page: Advanced Settings (Cont.)
TABLE 18
Option
Gratuitous ARP
ARP Interval (secs)
Unsolicited Status
Send Status Address
Status Interval (secs)
Discovery Packet
Transmit
Discovery Interval
(secs)
IR Command Holdoff
IR Repeat Holdoff
IGMP Joins on Stream
Loss
IGMP Join Interval
Enable SNMP
N3000 Series User Manual
Description
Enable the Decoder to send a periodic Address
Resolution Protocol (ARP) packet to the network.
Determine how often (in seconds) the unit transmits
gratuitous ARP packets.
Enable the Decoder to send a periodic status packet to
the Send Status Address described below.
When Unsolicited Status is enabled, the Decoder sends
a periodic status packet to the IP address specified
here.
Determine how often (in seconds) the unit transmits
status packets.
Enable the SVSI multicast discovery service (which is
used to identify units).
Determine how often (in seconds) the unit transmits
discovery packets.
Set the delay between IR command portions. The
default setting is 25 ms.
Set the repeat delay between IR commands. The default
setting is 90 ms.
Enable to send Internet Group Management Protocol
(IGMP) join messages when no incoming stream is
detected.
Delay in seconds between sending IGMP join messages
(if IGMP Joins on Stream Loss is enabled).
Enable to allow the device to send Simple Network
Management Protocol (SNMP) packets.
Decoder Configuration Options
Notes
This is useful for larger network integrations when
broadcast packets will not cover the entire network.
Enabled by default.
IR commands are sent in two parts. This setting is the
time (in milliseconds) between transmission of part
one and part two. The second part of the command is
inverted for confirmation purposes.
This is the amount of time before a new command is
sent. For example, when pressing and holding the
volume button on a remote control, this is how long
until the command is repeated.
53