AMX NMX-ENC-N3121 Instruction Manual page 44

Record Page Options (Cont.)
TABLE 14
Option
Stream URL
USB Port
File section
Base Name
Convert to MP4
Validate after send
File Transfer Settings section
Transfer Method
Server Port (FTP or
SFTP)
Server Directory
(Share)
Destination IP Address
Server Username
Change Password
Delete after Transfer
File Transfer Schedule section
Unit Time
Schedule
Start Time
End Time Window
N3000 Series User Manual
Description
URL of the device's network stream. This is shown here for the convenience of users that do not have admin
privileges (and therefore cannot access the main page for this information).
Enable this setting BEFORE plugging in a compatible device into the USB port on the front of the Encoder. Once
the device is validated, Device Ready will display in the USB State field.
Specify a base name for the recording file. The actual file name will be the base name plus a time stamp.
Turn On if you wish to convert the file to an mp4 before transfer.
NOTE:
This requires twice the storage space on the USB drive.
Turn On if (after a file is transferred) you would like to automatically pull it back to the unit and verify that it
matches the original file.
NOTE: This requires twice the storage space on the USB drive.
Select a transfer method if you would like the file to be transferred somewhere once recording has stopped.
Options include SFTP, FTP, and Network Share.
If your Transfer Method is set to FTP or SFTP (see above) enter the port number to be used for transfer.
If your Transfer Method is set to Network Share (see above) enter the directory on the share where the file will
be stored.
The destination IP address applies to all Transfer Method modes. It is the address of the server that will receive
the file.
Enter the username to use when validating the file transfer to the server. The username applies to all modes.
Enter the password to use when validating the file transfer to the server. The password applies to all modes.
Turn On if you would like the file to automatically delete from the USB drive once it has been transferred via the
selected method.
NOTE: If you use this option, it is recommended that you also enable the Validate after send feature (to
make sure the recording made it to the server).
The Encoder's current time (read only). In order to get accurate real time, the Encoder must be on an IP
address that connects to the Internet and there must be a time server entered (under Settings>Time Settings).
See the Time Settings section on page 32 for more information.
Select when you would like recording files to be transferred. Choices include:
Never – Do not transfer the recordings.
Immediate – Begin transfer as soon as the recording has stopped.
At start time – All completed recordings will be transferred at the start time specified (see Start Time below).
Time window – The recordings will be transferred at a random time during the time window determined by the
Start Time and End Time Window settings (see below).
If Schedule is set to At start time or Time window, enter the time you would like to begin the recording transfer.
The time fields are set as a 24 hour clock (0:0 to 23:59).
If Schedule is set to Time Window, enter the time you would like to end the window during which recordings are
transferred. The time fields are set as a 24 hour clock (0:0 to 23:59).
Encoder Configuration Options
44