Stream Settings - AMX NMX-ENC-N3121 Instruction Manual

Stream Settings

The section of the Settings page shown in
Table 2.
Stream Settings Section
FIG. 22
Settings Page: Stream Settings Section
TABLE 2
Option
Encoder Output Mode
Transport Stream
Generate Multicast
Stream
RTP Encapsulation
HTTP File Duration (sec) Selects the duration (in seconds) of the individual
RTMP URL
RTMP Stream
PCM Audio
I-Frame Frequency
Multicast Address
Override
Multicast Address
UDP Port Number
N3000 Series User Manual
Figure 22 is displayed when you click the Stream Settings link. Options are described in
Description
Set the Encoder's output type to SVSI decoder, HTTP
live, RTSP, or RTMP.
Enable to encapsulate the stream as an MPEG2
transport stream
Enable to cause the Encoder to also generate an SVSI-
compatible multicast stream.
Enable to prepend RTP headers to the AV stream.
HTTP Live Streaming (HLS) files.
Specifies the content delivery service that you want to
send the stream to.
Specifies the content delivery service that you want to
send the stream to.
If enabled, the Encoder will also generate an SVSI-
compatible PCM audio stream.
Determines how often an I-frame is injected into the
stream. Example: If set to 10, one I-frame will be
injected for every ten frames.
Enable to override the upper two octets of the
multicast address with the values specified in the
Multicast Address field (see below).
If Multicast Address Override is enabled, enter the
upper two octets.
Specifies the UDP port number for the AV stream.
Encoder Configuration Options
Refer to Table 3 on page 29 for more details on
Encoder and Decoder configuration considerations
(based on which Encoder Output Mode option you
choose).
This setting only applies if Encoder Output Mode is
set to SVSI decoder.
This setting only applies if Encoder Output Mode is
set to HTTP live or RTMP.
This setting only applies if Encoder Output Mode is
set to SVSI decoder.
This setting only applies if Encoder Output Mode is
set to HTTP live.
This setting only applies if Encoder Output Mode is
set to RTMP.
This setting only applies if Encoder Output Mode is
set to RTMP.
A higher number in this field results in a better video
quality for the amount of bandwidth used. However,
keep in mind that this setting will affect switching
speed on the Decoder. The higher the number, the
more switching delay experienced.
28