Change Password Section; Software Section - AMX NMX-ENC-N3121 Instruction Manual

Change Password Section

The Change Password section of the settings page is shown in
admin-level access) enter the current password in the field labeled Old Password, and enter a new password in the New Password
and Conf irm Password fields. Click Change PW to accept the new password. To create/change the user password (which provides
access to the Record page of the N3132) use the Change User Password field and button at the bottom portion of this section.
Change Password
FIG. 29
NOTE: The admin password needs to match N-Able's stored password to allow auto-login using N-Able.

Software Section

The Software section of the Settings page is shown in
Software Section
FIG. 30
Settings Page: Software Section
TABLE 8
Option
Serial
MAC Address
Firmware Version
Web Version
Factory Restore
Reboot
N3000 Series User Manual
Figure
Description
Displays the serial number of the N3000 Encoder.
Displays the MAC address of the network interface of the N3000 Encoder.
Displays the date code for the currently running version of the N3000 Encoder internal firmware.
Displays the date code for the currently running version of the web interface.
Click to restore the device to the original factory settings. This resets everything except the IP address
(including name, stream number, serial settings, etc.). If you wish to factory restore all settings (including the IP
address) boot the box with the ID button held down.
Click to reboot the device (does not affect current configuration).
Figure 29. To change the N3000 Encoder interface password (for
30. Options are described in Table
Encoder Configuration Options
8.
36