Sd Card; Read Data From A Pc; Usb Port; Connectors - FUTABA T18MZ WC Instruction Manual

SD Card (sold separately)
The SD card can store various les, such as model
data, music, sound les and pictures. Any SD card
on the market can be used with the T18MZ-WC.
The card is locked when it is pushed in all the way
in. To remove the card, push in on the card again, it
will pop up allowing you to remove it.
*Write protection of SD card is turned OFF. In the state of
protection, model data cannot be saved on SD card.
WARNING
Be sure to turn off the power to the transmitter
before inserting or removing the SD card.
As the SD card is a precision device, do not use
excessive force when inserting.
If model data generated by a new software
version transmitter is copied to an old software
version transmitter, the transmitter may operate
erroneously. Copy the model data after updating
the copy destination transmitter to the new
software version.

Read data from a PC

Saving music and image les edited by a PC into the
SD card, you can use those files on your T18MZ-
WC transmitter. Equipment for reading and writing
SD cards are available at most electronics stores.
Stored data
The life of the SD card is limited due to the use
of flash memory. If you have a problem saving or
reading data such as picture data after a long period
of use you may need to purchase a new SD card.
*We are not responsible for, and cannot compensate for any
failure to the data stored in the memory card for any reason.
Be sure to keep a backup of your models and data in your SD
card.
*No need for backup battery; T18MZ-WC transmitters and
SD cards are using nonvolatile memory devices so that the
data stored in those will not be destroyed even without a
backup battery. The clock for the transmitter depends on the
Lithium battery.
Update Switch
When using an SD card to update the T18MZ-WC
software, set this switch to the up position. Then
input the software to be updated to the SD card
from the Futaba importers homepage and update the
software in accordance with the updating procedure.

USB port

The following functions can be used with USB
connector.
• USB Mouse
When a mouse is connected, a cursor will
appear on the screen and the mouse can be
used instead of the touch panel.
• USB Keybord
When a keyboard is connected, the model
name and other data can be input by
keyboard.
• USB Memory
All model data, etc. can be saved to an
optional USB Memory stick.
Connector for trainer function (TRAINER)
When you use trainer function, connect the optional
trainer cable between the transmitters for teacher and
student.
*You can set the trainer function on the Trainer Function screen
in the system menu
Connector for DSC function (DSC)
You can operate the transmitter without transmitting
radio waves by connecting the transmitter and the
receiver to the DSC cable.
*Please refer to the section "Connection between Receiver/
Servo"
S.BUS connector (S.I/F)
When setting an S.BUS servo and telemetry sensor,
connect them both here.
(Supply power by 3-way hub or 2-way cord.)
Audio plug (PHONE)
Connecting a stereo headphone to this plug, you can
enjoy music les stored in the SD card.
Connector for battery charger (CHG)
You cannot use the charger that was included with
the transmitter, without using the AC adapter that
comes with this.
DANGER
Do not connect any other chargers. The charger
for the receiver battery cannot be used for the
transmitter.
USB port (mini-B)
*This is for factory use only.
＜ Before Use ＞
23