Sd Card - FUTABA FASSTest-2.4GHz T18SZ Series Instruction Manual

SD Card (secure digital memory card) (not included)
The T18SZ transmitter model data can be stored by using any commonly found SD card. When T18SZ
transmitter update software is released, the software is updated using an SD card. The T18SZ is capable of
using SD cards with a memory size between 32MB and 2GB.
SD card reader/writer
Saving model data and update files (released
from Futaba) into the SD card, you can use those
files on your T18SZ transmitter. Equipment for
reading and writing SD cards is available at most
electronics stores.
Stored data
When you have a problem of saving or reading
data after a long period of use, please get a new SD
card.
*We do not have the responsibility of compensating any
failure or damage to the data stored in the memory card no
matter what the reason is. Be sure to keep a backup of your
important data in your SD card.
Inserting/removing the SD card
① A side battery cover
is opened.
Battery cover
SD card slot
②The SD card slot is
show here in the
figure below.
*Don't mistake the both sides/ the direction of

SD card.

CAUTION
Be sure to turn off the power to the
transmitter before inserting or removing
the SD card.
As the SD card is a precision device, do not
use excessive force when inserting.
SD card slot
③ When the SD card
is pressed in once
again, the card will
be released from the
card slot. and can be
removed.
<Before Use> 25