S.bus2 System; S.bus Device Setting - FUTABA T18MZ WC Instruction Manual

When using the S.BUS2 port, an impressive array of telemetry sensors may be utilized.
S.BUS Servo
Receiver port
S.BUS Gyro
S.BUS
S.BUS2
× （※）
（※）
S.BUS servos and gyros and S.BUS2
servos and gyros must be used in the
correct receiver ports. Please refer to
the instruction manual to make sure
you connect to the correct one.
S.BUS servos or a telemetry sensor can be connected directly to the T18MZ-WC. Channel setting and other
data can be entered for the S.BUS servos or sensors.
S.BUS2 Servo
S.BUS2
Gyro
○ ○
○
3-way hub
or 2-way
Telemetry
sensor
×
○
1. Connect the S.BUS device and battery you
want to set with a 3-way hub or 2-way cord
2. Turn on the transmitter power.
3. Call the setup screen.
Servo: System Menu → S.BUS Servo
Sensor: Linkage Menu → Sensor
4. Perform setting in accordance with each
screen.
5. This sets the channel and other data for each
S.BUS servo, or telemetry device to be used
with the S.BUS device or receiver.
＜ Before Use ＞
33