Led Monitor; Switch Reallocation; Rotating Antenna - FUTABA T18MZ WC Instruction Manual

•Rotating antenna

The antenna can be rotated 90 degrees and angled 90
degrees. Forcing the antenna further than this can
damage it. The antenna is not removable.
•Angle adjustment of the antenna
The antenna rotation and angle can be adjusted. The
antenna features weak radio waves in the forward
direction and strong radio waves in the sideways
directions. Adjust the antenna angle to match your
ying style.
180°
90°

LED monitor

The status of the transmitter is displayed by changing
the "MONITOR" section LED.
(LED Display)
◆ FASSTest mode → Light Blue light
◆ FASST mode → Green light
◆ S-FHSS/T-FHSS mode → yellow-green light
◆ RF-OFF → Violet light
◆ Starting → Red light
◆ Trainer Student → Blue light

Switch reallocation

You can reallocate the toggle switches on the
shoulders of the transmitter, as you like.
(Default settings)
• SA : 3 positions; Alternate; Short lever
• SB : 3 positions; Alternate; Long lever
• SC : 3 positions; Alternate; Long lever
• SD : 3 positions; Alternate; Short lever
• SE : 3 positions; Alternate; Short lever
• SF : 2 positions; Alternate; Long lever
• SG : 2 positions; Alternate; Short lever
• SH : 2 positions; Momentary; Long lever
*You can choose the Switch and the On/Off position in the
Switch Selection menu of your mix.
•When you change switches:
To relocate switches;
1. Make sure your transmitter is off, and use
the attached 2.5mm hexagonal wrench
(included) to turn the screw counter-clockwise
on the switch block and detach the block.
Remove the screw holding the switch block.
Pull up on the switch block to remove it.
2. Disconnect the connectors of switches you
want to change.
3. Use the attached jig (inside stylus) to turn the
＜ Before Use ＞
15