Micro Sd Card - FUTABA FMT-03 Instruction Manual

Micro SD card

(secure digital memory card) (not
included)
The FMT-03 transmitter model data
can be stored by using any commonly
found micro SD card. When FMT-
03 transmitter update software is
released, the software is updated using
an micro SD card. The FMT-03 is
capable of using micro SD cards with
a memory size between SD:32MB
-2GB SDHC:4GB-32GB.
CAUTION
Be sure to turn off the power to the
transmitter before inserting or removing
the micro SD card.
As the micro SD card is a precision device,
do not use excessive force when inserting.
20 <Before Use>
Micro SD card reader/writer
Saving model data and update files (released
from Futaba) into the micro SD card, you can use
those files on your FMT-03 transmitter. Equipment
for reading and writing micro SD cards is available
at most electronics stores.
Stored data
When you have a problem of saving or reading
data after a long period of use, please get a new
micro SD card.
*We do not have the responsibility of compensating any
failure or damage to the data stored in the memory card no
matter what the reason is. Be sure to keep a backup of your
important data in your micro SD card.
Inserting/removing the micro SD card
① Open the battery cover. (Minus driver is used.)
SD card slot
*Don't mistake the
direction that the
micro SD card is
inserted.
② It inserts until it locks micro SD card into SD card slot.
*It is releasable if a card is pushed once again.