Micro Sd Card - FUTABA T16IZ Short Manual

micro SD card (secure digital memory card) (not included)
The T16IZ transmitter model data can be stored by using any commonly
found micro SD card. When T16IZ transmitter update software is released, the
software is updated using an micro SD card. The T16IZ is capable of using SD
and SDHC cards (SD:32MB-2GB SDHC:4GB-32GB).
micro SD card reader/writer
Saving model data and update files (released from
Futaba) into the micro SD card, you can use those
files on your T16IZ transmitter. Equipment for
reading and writing SD cards is available at most
electronics stores.
Inserting/removing the micro SD card
1） Rotate the antenna.
The micro SD card slot is shown here in the figure below.
SD card slot
*Pay attention to the proper
orientation of the SD card, as
shown here.
Stored data
When you have a problem of saving or reading data
after a long period of use, please get a new micro
SD card.
*We are not responsible for, and offer no compensation for,
memory card data that fails or is damaged for any reason.
Be sure to keep a backup of all important data stored in your

micro SD card.

2） Open the rubber cover and insert the
micro SD card into the micro SD card slot.
3） When the micro SD card is pressed in once
again, the card will be released from the
card slot and can be removed.
Card slot
21