Helicopter Basic Setting Procedure; Model Type And Swash Type Selection - FUTABA T18MZ WC Instruction Manual

1. Model addition and call
Default settings assign one model to the T18MZ-
WC transmitter. To add new models or select
previously setup models, use the Model Select
function in the Linkage Menu.
This is convenient when calling a model after
registering the model names in advance. (Data can
also be saved to the accessory SD card and USB
memory)
The currently called model is displayed at the top
of the screen. Before ying and before changing any
settings, always con rm the model name.
Please be aware that the transmitter will stop
transmitting when you change the model.
When a new model is added, the model type select
screen/system mode/receiver link automatically
appears. Please be aware that the transmitter will
stop transmitting when you change the model.

2. Model type and swash type selection

When a separate model type is already selected,
select helicopter with the Model Type function of
the Linkage Menu, and then select the swash type
matched to the fuselage.
42 2
＜ ＜ ＜ Model Basic Setting Procedure ＞
Mode del Mo l Basi Ba sic c
＞ ＞
Sett Se ttin ing g Proc Pr oced edur ure e
3. Flight condition addition
The transmitter can install up to eight flight
conditions per model. You can assign all switches
including sticks, switches, trim levers and trim
switches as ight-condition selection switches. You
can also add delayed mixing to these functions in
order to avoid sudden changes. Moreover, you can
set priority order for ight conditions when you set
more than one condition. In addition, you can copy
conditions and/or change names of conditions. This
command may also be used to de ne what switches
and/or controls are used to activate each flight
condition.
The Condition Select function automatically
allocates the default Condition 0 (Normal) for each
model type. Condition 0 (Normal) is the only one
active when a new model type is defined. This
condition is always ON, and remains ON until other
conditions are activated by switches.
The Condition Delay can be programmed for each
channel. The Condition Delay is used to change the
servo throw smoothly when switching conditions.
when switch OFF)
SW-E center)
SW-E forward side)
at SW-G forward side)
The priority is throttle hold/idle up 2/idle up 1/
normal. Throttle hold has the highest priority.
Add other conditions, as required.