Trainer; Student Mode; Corresponding Types Of Transmitters And Trainer Mode Settings - FUTABA T18MZ WC Instruction Manual

T18MZ-WC trainer system makes it possible
for the instructor to chose which channels and
operation modes that can be used in the student's
transmitter. The function and rate of each channel
can be set, the training method can also be matched
to the student's skill level. Two transmitters must
be connected by an optional Trainer Cord, and the
Instructors' transmitter should be programmed for
trainer operation, as described below.
When the Instructor activates the trainer switch, the
student has control of the aircraft (if MIX/ FUNC/
NORM mode is turned on, the Instructor can make
corrections while the student has control). When
the switch is released the Instructor regains control.
This is very useful if the student gets the aircraft
into an undesirable situation.

Corresponding types of transmitters and trainer mode settings:

Student mode

52
＜ System Menu ＞
Notes: This trainer system can be used in the
following manner;
1. In the T18MZ(WC) (including FX-40, T12Z
and T12FG) transmitter and a conventional
transmitter, if the channel order is different.
It is necessary to match the channel order
in the Linkage Menu when connecting it
with other than a T18MZ(WC). Or use "Trainer
student channel setting function"
2. Be sure that all channels work correctly in
Note: In "student mode", only the teacher side
can turn on and off the power of the student's
transmitter. Keep the power switch always at
off position.