Throttle Curve Setting - FUTABA T18MZ WC Instruction Manual

4. Fuselage linkage
Connect the throttle rudder, ailerons, elevators,
pitch, and other rudder linkages in accordance with
the kit instruction manual. For a description of
the connection method, see "Receiver and servos
connection".
*The channel assignment of the T18MZ-WC is different from
that of our existing systems. (The channel assigned to each
function can be checked at the function menu of the Linkage
Menu.)
use the Reverse function of the Linkage Menu.
set up other than the H-1 mode.
(Gyro side function)
with the trim setting all the way down.
Trim function and End Point function (rudder
angle adjustment). To protect the linkage, a
limit position can also be set with the End Point
function.
Operation of the swash plate near the hovering point
operation causes the swash plate to deviate from
the normal direction.
(Call the Swash setup Swash details screen.)
Pitch slow side and high side linkage correction is also
swash plate to move up and down in the horizontal
state.

5. Throttle curve setting

This function adjusts the pitch operation curve
in relation to the movement of the throttle stick for
each condition.
(17 points curve)
The pitch curve can be freely selected from linear
operation curve to smooth curve, and adjusted to
match the curve you want by means of the T18MZ-
WC's powerful Curve Edit Function (6 types of
curves can be selected). Up to 17 points can be set
for linear or curve types. However, when using the
3 points or 5 points specified to create a curve, a
simple and smooth curve can be created by selecting
the curve type and reducing the number of input
points to 3 or 5, and then entering the speci ed value
at the corresponding points that you created.
Call the throttle curve of each condition with the
condition select switch.
Normal curve uses Normal (Linear) type and creates
a basic pitch curve centered near hovering. This
curve is adjusted together with the Throttle Curve
(Normal) so that the engine speed is constant and
up/down control is easiest.
The high side pitch curve sets the maximum pitch
regardless of the engine load. The low side pitch
curve creates a curve matched for aerobatics (loop,
roll, 3D, etc.).
Note: When the curve type is changed, the data is
reset.
＜ Model Basic Setting Procedure ＞
43