This function is for adjusting the sticks, switches,
and trim characteristics. It is not unless necessary.
H/W Reverse
This function reverses the operation signal of the
sticks, switches, trimmer levers, and knobs.
Note: This setting reverses the actual operation
signal, but does not change the display of
the indicators on the display. Use the Normal
mode as long as there is no special reason to
use the Reverse mode.
Operation direction reversal method
Stick Setting
This function sets the servo response and hysteresis
for stick operation for each condition. The control
feeling of the stick can be adjusted to match the
aerobatics.
Calibration
Usually, this calibration is unnecessary.
Please perform this calibration, only if a change at
the center of a stick should arise after prolonged use.
< System Menu >
59