System Type; Receiver Linking; Dual Receiver Function; Battery Fail-Safe Voltage Setup - FUTABA T18MZ WC Instruction Manual

System Type selection
The T18MZ-WC is for 2.4GHz only. The system
can be changed from among 5 choices: FASSTest
18CH, FASSTest 12CH, FASST MULTI, FASST
7CH, S-FHSS, T-FHSS. Select the system
matched to the type of receiver you are
*Even if it changes a system type, other model data is not
reset.e
*If a system type is changed in the case of a helicopter, It
can choose out of two channel orders.
[Yes] : Selection sets the channel order suitable for system
type. (We recommend here.)
[No] : The present channel order is maintained.
*All control surfaces should be checked for the correct
operating directions and operating smoothness before
ying the model.
*Analog servos cannot be used with the R7008SB in the
FASSTest 12CH mode.

Receiver linking

The receiver will only be controlled (without
being affected by other transmitters) by the
transmitter it is linked to. When using a receiver
other than one purchased as a set, linking is
necessary.
Moreover, a re-link is required when a new model
is added by model selection, and the time of
system type change.
Dual receiver function (only FASSTest 18CH
mode)
Dual receivers can be linked with the T18MZ-
WC. Two receivers are recognized individually
by ID numbers. For example, in R7008SB, CH
output setting function is used, by setting the
rst as as "1-8CH", and setting the second as "9-
78
＜ Linkage Menu ＞
16CH", two sets of receivers can be used as a set
in the model, allowing you 16 channels. If a dual
receiver function is used, the following function can
set up individually.
・ Battery fail-safe voltage setup
using.u
A telemetry function cannot be used for the 2nd
receiver. The voltage and Ext voltage of a 2nd
receiver cannot be known with a transmitter.
Telemetry function (only FASSTest mode)
To use the telemetry function, set "Telemetry" to
"ON".
D/L Interval (only FASSTest mode)
When a telemetry function is enabled, the receiving
interval (down-link interval) of sensor data can be
changed.
If a D/L interval is increased, the response of
the sensor data display becomes slower, but stick
response will improve.
Battery fail-safe voltage setup (FASSTest /
T-FHSS mode)
The voltage which battery fail-safe activates, can
be set when you link. (3.5-8.4V) The receiver
memorizes the setting as it was at link.
Suggested setting voltages are as follows.
• 4 cells NiCd or NiMH (Normal: 4.8v) = 3.8 v
• 2 cells LiFe (Normal: 6.6 v) = 6.0 ~ 6.2 v
• 2 cells LiPo (Normal: 7.4 v) = 7.2 ~ 7.4 v
It is a rough reference value.
Since it changes with servos carried in the condition
and the model of a battery, please set to your own
model in a battery consumption current.