This function is used when a gyro is used to
stabilize the fuselage attitude. The sensitivity and
operation mode (Normal mode/GYmode) can be
switched with a switch.
simultaneously controlled.
5CH → GYRO
Rate
1
2
3
*Set so that Rate 1 is turned on at the back position of switch
E and Rate 3 is turned ON at the front position. Since switch
E is turned OFF at the center, Rate 2 remains [INH].
AVCS
GAIN 0%
NORMAL
When AVCS is used we
recommend that the
sensitivity CH be set to
the 3-position.
7CH → GYRO2
ACT
Type
Switch
OFF/ON
GY
SE
INH
ON/OFF
GY
SE
S.BUS2 port
< Model Menu (Airplane/Glider Functions) >
*Initial setting does not assign a sensitivity channel. Use the
Function menu of the Linkage Menu to assign the sensitivity
channel (Gyro/Gyro2/Gyro3) used to a vacant channel
beforehand.
Set [ACT] and [Trim] other than Function to [NULL].
(For more information, see the description
8CH → GYRO3
GYRO
GYRO 2
AVCS : 60% AVCS : 60% AVCS : 60%
NORM : 60% NORM : 60% NORM : 60%
R7008SB
GYA431
GYA431
GYA430
Control and Trim → NULL
GYRO 3
Aileron servo
Elevator servo
Rudder servo
143