Throttle Hover Trim - FUTABA T18MZ WC Instruction Manual

Curve setting examples
The curves shown below were created by using the
Line mode and inputting the data of the 5 points
0% (low side), 25%, 50% (center), 75%, 100%
(high) side at each condition. They were created by
reducing the number points of the line to 5. When
ro le Curve
Normal Curve
The Throttle Hover trim setup screen can be called from the THR Curve setup screen.
The Throttle Hover function trims the throttle near
the hovering point. Normally, use it with hovering
conditions. Changes in rotor speed accompanying
changes in the temperature, humidity, and other ight
conditions can be trimmed. Adjust the throttle so that
rotor rotation is most stable. More delicate trimming
is also possible by using this function along with the
Hover Pitch function.
ample
Idle-up 1 Curve
actually creating a curve, enter the data speci ed per
the fuselage (or the reference value).
Idle-up 2 Curve
Setting method
CTRM mode:
NORM mode:
＜ Model Menu (Helicopter Functions) ＞
157