Mounting The Carry Handle - Barco CLM HD8 User Manual

F. Mounting optional Carry handle
Image F-5
3. Insert next to the removed back foot the extra support point (reference 1). Use a 22mm open-end wrench to fasten the extra
support.
Due to its construction, the support is still a bit movable.
1
Image F-6
F.4

Mounting the carry handle

Necessary tools
• 8 mm Allen wrench.
• 4 mm Allen wrench.
• 2,5 mm Allen wrench.
Necessary parts
• One spacer rotation ring.
• One flat spacer.
• One hexagon socket head cap screws M10 x 20.
• Three hexagon socket head cap screws M10 x 40.
• Four hexagon socket head cap screws M5 x 10.
How to mount the carry handle?
1. Place the carry handle upon the bottom of the projector as illustrated.
2. Insert the spacer rotation ring (reference 4) and a hexagon socket head cap screw M10 x 40 (reference 1) in the back fixation
hole so that a small rotation of the carry handle is still possible.
3. Insert a flat spacer (reference 3) and a hexagon socket head cap screw M10 x 20 (reference 2) in the fixation hole of the extra
support point.
4. Insert a hexagon socket head cap screw (reference 1) into both fixation holes at the front of the carry handle.
Note: If both front holes are not completely free, turn on the skew adjustment (reference 5) at the right side of the carry handle
until the holes are free.
204
1
2
3
R59770057 CLM HD8 14/01/2009