Errors, Warnings And Messages During Start Up; Switching To Standby - Barco CLM HD8 User Manual

6. Getting started
2 3 4
1
6 8 9
7
RGB PATTERN WINDOW PIP
STBY PAUSE TEXT AUTO
A
Image 6-3
Stand by indication
A Stand by indication on local keypad
B Stand by indication on remote control
The projector status LED lights up.
The projector starts up on the last saved source.
Some lamp and runtime warnings can be displayed when an image is displayed after a start up.
6.3.2

Errors, warnings and messages during start up

Temperature error DMD
When the temperature of the DMD is too low or too high, the projector produces an error message.
When the DMD temperature is too low:
• Lower than 0°C, warning is displayed on the LCD panel and yellow warning LED is on. Both remains until the temperature is
above 10°C.
• Between 0°C and 10°C, projector starts up normally with a warning on the LCD panel and the yellow warning LED lights up,
but only for 10 minutes. When the temperature is then not above 10°C the projector goes in standby.
When the DMD temperature is too high:
When temperature is between 60°C and 65°C, the lamp mode will be reduced from 4 lamps to 2 lamps or 1 lamp.
•
• When temperature is higher than 65°C, the projector switches to standby.
For a list of possible error codes, see "Error codes", page 195.
6.3.3

Switching to standby

How to switch to standby?
1. Press Standby to switch the projector to standby.
Switching to Standby. When the projector is running and you want to go to standby, press the standby key
for 2 seconds. Do not press any longer on the standby key otherwise the projector will restart.
46
B
5
EXIT
MENU
0
LENS
ENTER
RIGGING
MENU
EXIT
ENTER
PAUSE LENS TEXT
PHASE
9 0
SHARPN
8
7
TINT
6
5
COLOR
3 4
BRIGHTN
1 2
CONTR
LENS LENS
ZOOM SHIFT
LENS LENS
SHIFT
FOCUS
R59770057 CLM HD8 14/01/2009