Switching Off; Using The Rcu - Barco CLM HD8 User Manual

All custom settings are written to the internal backup device. A message 'Save data ...' indicates this process.
Never switch off the projector while this message is displayed.
6.3.4

Switching off

How to switch off the projector?
1. Press first Standby.
2. Let cool down the projector until the fans decrease, at least 5 min.
3. Switch off the projector with the power switch.
C
AUTION
6.4

Using the RCU

Pointing to the reflective screen
1. Point the front of the RCU to the reflective screen surface.
Screen (B)
Image 6-4
IR control via the reflective screen
Hardwired to the XLR input
1. Plug one end of the remote cable in the connector on the bottom of the RCU
2. Plug the other end in the big connector in the input panel of the projector labelled Remote CTRL in.
Directly to one of the IR sensors
When using the wireless remote control, make sure you are within the effective operating distance (30m, 100ft in a straight line). The
remote control unit will not function properly if strong light strikes the sensor window or if there are obstacles between the remote
control unit and the projector IR sensor.
R59770057 CLM HD8 14/01/2009
:
Never switch off the projector while the message 'Save data ... ' is displayed !
IR Sensor (C)
Remote Control (A)
6. Getting started
47