Controlling The Projector; Source Selection - Barco CLM HD8 User Manual

6. Getting started
The LED on the remote control must lit up while pressing a digit key. Otherwise the address is not entered in
the remote control.
6.7.2

Controlling the projector

Projector address
Address installed in the projector to be individually controlled.
Common address
Projector will always execute the command coming from a RCU programmed with that common address.
Why a projector address ?
As more than one projector can be installed in a room, each projector should be separately addressable with an RCU or computer.
Therefore each projector has its own address.
Set up an individual Projector Address.
The set up of a projector address can be done via the software. See chapter 'Projector Control', 'Projector address'.
Projector controlling.
Every projector requires an individual address between 0 and 255 which can be set in the Service mode.
When the address is set, the projector can be controlled now:
• RCU for addresses between 0 and 9.
• computer, e.g. IBM PC (or compatible), Apple MAC, etc. for addresses between 0 and 255.
Common Address
Every projector has a common address '0' or '1'. The choice between '0' and '1' can be selected in Projector Control → Projector
address → Common address.
6.8

Source selection

Source selection when no picture in picture is active
Use the digit keys on the remote control or local keypad to active the desired source.
Source selection when picture in picture is active
Use the Window button on the remote control or the local keypad to select the main window or the picture in picture (PiP) window.
2 3 4
1
6 8 9
7
RGB PATTERN WINDOW PIP
STBY PAUSE TEXT AUTO
Image 6-16
Window selection button
The outline of the selected window gets a colored rectangle to indicate the selection. For the main window, the color is blue. For the
picture in picture window, the color is orange.
52
5
MENU EXIT
0
LENS
ENTER
RIGGING
MENU
EXIT
ENTER
PAUSE LENS TEXT
PHASE
R59770057 CLM HD8 14/01/2009