Usb Port - Barco CLM HD8 User Manual

10/100 Base-T — RJ45 port
Pin Description
6 RXD-
—
7
—
8

USB port

The communication interface is equipped with a master USB port, type "A" connector (H). This USB port will simplify the service
procedures for software updates or for taking backup files from the projector without network connection. An USB-stick is plugged
into the USB port and files can be transferred from or to the projector using the local or remote control unit. Note that the USB-stick
has to be Linux FAT16 compatible.
DMX interface
The communication interface of the CLM HD8 supports DMX.
DMX is used as communication bus between different devices in the light technic. Each device has an input and an output, so that
the bus can be looped between the different devices. According the standard a five wire cable with XLR connector is used but mostly
3-wire cables are used.
You can use the DMX input port (G) to connect a DMX device to the CLM projector. This way you can control the CLM projector
from that DMX device. The DMX output port (G) can be connected with the next device in the loop.
Pin
1
2
3
4
5
DMX
DMX-512 Lighting protocol over RS-485 interface. Carries information of 512 channels from a lighting controller to
lighting devices. Standardized by USITT.
R59770057 CLM HD8 14/01/2009
Description
Earth
Cold
Hot
Return - (or not used)
Return + (or not used)
5. Connections
41