Radio Installation - Hangar 9 Taylorcraft 20cc ARF Assembly Manual

Radio Installation

Parts Required
Fuselage Deluxe chargeswitch
Receiver 12-inch extension lead (2)
Receiver battery Cable ties (small)
Tools Required
Hook and loop strap #0 Phillips screwdriver
Scissors Double-sided adhesive
tape
Thin CA Dental floss
Step 1
Use a #0 Phillips screwdriver to install a chargeswitch
in the pre-cut location on the left hand fuselage floor.
Use the self-tapping screws provided with the switch.
Hangar 9 Taylorcraft 20cc Assembly Manual
Step 2
Use scissors to cut an 8-inch length of hook and loop
strap and loop it through the slots on the right hand
side of the radio compartment.
Step 3
Attach the recevier battery to the radio compartment
floor with double-sided tape then fasten the hook and
loop tape over the battery.
Step 4
Connect the battery lead to the chargeswitch and
secure the connection with dental floss. Apply a small
amount of thin CA to the knot so that it doesn't
become loose.
Step 5
Use scissors to cut a 7-inch length of hook and loop
strap and loop it through the slots on the left hand
side of the radio compartment.
41